Materials Used
- T-10 Torx Driver
- Small Phillips Head Screwdriver
- Alcohol and Q-tips
- A Nail File
Instructions
The first thing you'll need to do is detach the neck from the base using the unlock lever on the back of the guitar (picture 1.) After that, remove every screw--except the one for the neck strap--with the Torx driver. With the neck face down, remove the plastic back cover.You should now see a long circuit board, held to the casing by two small Phillips head screws. Once removed a thin rubber mat will be exposed. This mat has tiny contacts that complete the circuit when a button is pressed, signaling the game. The rubber material is also what makes the buttons bounce back into position when they're released. Set the mat aside.
You should finally see 5 colored buttons. Remove each, noting their location. Using the alcohol and Q-tips, clean any gunk from the sides of the buttons, and the slots they slide into. In my case, the plastic notches on the buttons had become warped, causing them to stick. Using the nail file I slightly sanded the sides of the plastic buttons, making it easier for them to move.
When done, I slid the buttons back into their holes, placed the rubber mat back on (contacts up), screwed the circuit board back in, and then reconnected the back of the neck. Note that I didn't detach the white cables from the circuit board when unscrewing it from the casing. I also didn't clean the contacts on the rubber mat and circuit board with alcohol, which might would have been necessary if any liquids had made their way into the neck.
I hope this short guide helps. I'm not responsible for any damage you do to your guitar. Check out the pictures below to see what you're getting into:




